Description
A 36" gas range with 4 open burners and a 12" griddle over a cabinet base.
The Southbend S-Series S36C-1G is built for restaurants, cafés and smaller kitchens that need burners, a griddle and storage in one 36.5" footprint. The top has 4 cast iron non-clog burners (28,000 BTU each on natural gas) and a 12" manual griddle on the left with a 1/2" thick smooth, polished steel plate. Below is a cabinet base for storage instead of an oven. It needs one 3/4" gas connection; no electrical hookup is listed for this model, and it must be installed under a vented hood.
Will it fit · Will it hook up
- Outside size
- 36.5" W × 34" D × 59.5" H, including the 22.5" flue riser and shelf
- Cooking height
- 37" to the cooking top, on 6" adjustable legs
- Crate size
- 44" W × 45.5" D × 48" H
- Gas
- One 3/4" male connection at the rear, on the right side (opposite the left-hand griddle); minimum 7" W.C. natural gas or 11" W.C. propane
- Heat input
- 130,000 BTU natural gas (4 × 28,000 + 18,000)
- Electrical
- None listed for this model
- Clearances
- 10" sides and rear from combustible construction, 0" from noncombustible; under a vented hood
Dimensions are from Southbend's S-Series 36" spec sheet (Form S36G Rev 10, May 2022). Measure every doorway and turn on the delivery path before ordering; the flue riser and shelf come off the range and are installed on site.
4 non-clog burners
One-piece cast iron non-clog burners with a lifetime warranty, rated 28,000 BTU each on natural gas (24,000 BTU on propane), under individual removable cast iron grates; the rear grates hold up to a 14" stock pot.
12" griddle on the left
A 1/2" thick smooth, polished steel plate with raised sides, heated by 1 burner at 18,000 BTU and set with manual controls.
Cabinet storage
An aluminized cabinet base in place of an oven. It ships without doors; doors that open from the center are a no-charge factory option.
Easy to keep clean
A removable one-piece crumb drawer sits under the burners, the front, sides and shelf are stainless steel, and a 4" stainless front rail has welded end caps.
Ready to connect
A factory-installed pressure regulator and a single 3/4" rear gas connection. CSA design certified, NSF and made in the USA.
Delivery and setup
- Ships by freight carrier. See our shipping policy for delivery details, and call us for the current lead time.
- The flue riser and shelf ship on the range and are lifted off for installation; the 4 legs screw into the leg pads.
- Tell us natural gas or propane when you order; the gas type is set at the factory.
- Inspect the shipment before signing for it and note any damage on the bill. Report concealed damage to the carrier within 15 days.
- Have a qualified gas installer connect the range, check the regulator pressure and follow local codes.
Questions buyers ask
Does it have an oven?
No. The C in the model number means a cabinet base for storage instead of an oven. Southbend ships cabinets without doors; doors that open from the center are a no-charge factory option, so ask us when you order.
Natural gas or propane?
Southbend builds the range for one gas at the factory, so tell us your gas type when ordering. The natural gas rating is 130,000 BTU; open burners are rated 24,000 BTU each on propane.
What gas hookup does it need?
One 3/4" male connection at the rear. Because the griddle is on the left, the connection is on the right side. Minimum inlet pressure is 7" W.C. for natural gas and 11" W.C. for propane, and a pressure regulator is installed at the factory.
Does it need electricity?
Southbend lists electrical service only for convection-oven versions of the S-Series. The S36C-1G has no convection oven, and its spec sheet lists no electrical connection.
How close can it go to a wall?
Allow 10" at the sides and rear from combustible construction; 0" is allowed to noncombustible construction. Install it under a vented hood and check local fire and gas codes.
Will it fit through my door?
The range is 36.5" wide and 34" deep without the crate, and it ships in a 44" W x 45.5" D x 48" H crate. Measure every doorway and turn on the delivery path first.
Can it go on any floor?
Southbend says to contact the factory before installing on a floor other than quarry tile, cement or natural stone, because damage from improper installation is not covered. Ask us and we will check the options with Southbend.
What does the warranty cover?
Southbend covers defects in parts and labor for 1 year from purchase, serviced by a Southbend Authorized Service Agency, and no longer than 18 months from the factory. Spark igniters, seals and similar wear parts are limited to 90 days, and damage from improper installation, ventilation or misuse is not covered.
Specs
| Manufacturer | Southbend |
|---|---|
| Model Number | S36C-1G |
| Series | S-Series Restaurant Range, 36" Series |
| Quantity | 1 Each |
| Width | 36.5 Inches |
| Depth | 34 Inches |
| Height | 59.5 Inches (with 22.5" Flue Riser and Shelf) |
| Cooking Height | 37 Inches |
| Crate Size | 44" W x 45.5" D x 48" H (55.6 cu. ft.) |
| Legs | 6" Stainless Steel Adjustable Legs (Casters Optional) |
| Top Configuration | 4 Open Burners (Right)12" Manual Griddle (Left) |
| Burners | 4 One-Piece Cast Iron Non-Clog BurnersIndividual Removable Cast Iron Grates (Rear Holds Up to 14" Stock Pot) |
| Burner BTU | 28,000 BTU/H Each (Natural Gas)24,000 BTU/H Each (Propane) |
| Griddle | 12" W, 1/2" Thick Smooth Polished Steel Plate with Raised SidesManual Controls1 x 18,000 BTU/H Burner |
| Cabinet Base | 1 x Aluminized CabinetShips Without Doors; Doors That Open from the Center Are a No-Charge Option |
| Cabinet Opening Height | 16.5 Inches |
| Total BTU (Natural Gas) | 130,000 BTU/H (4 x 28,000 + 18,000) |
| Propane Ratings | Open Burners 24,000 BTU/H Each |
| Gas Type | Natural Gas or Propane (Set at the Factory; Specify When Ordering) |
| Gas Connection | 3/4" Male at Rear, Right Side (Opposite the Griddle) |
| Minimum Inlet Pressure | 7" W.C. Natural Gas11" W.C. Propane |
| Pressure Regulator | Factory Installed |
| Electrical | None Listed for This Model |
| Exterior | Stainless Steel Front, Sides and Removable Shelf4" Stainless Steel Front Rail with Welded End Caps |
| Crumb Drawers | Removable One-Piece Crumb Drawer Under Burners |
| Clearances | 10" Sides and Rear from Combustible Construction0" from Noncombustible Construction |
| Ventilation | Install Under a Vented Hood |
| Certifications | CSA Design Certified (C/US)NSFMade in USA |
| Warranty | 1 Year Parts and Labor (Southbend Limited Warranty) |
| Usage | Commercial Use Only |
Certifications
Payment & Security
Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.