Hatco UGAL-66D Ultra-Glo Ceramic Dual Infrared Strip Heater with Lights, 66" W, 3" Spacer, 4,220 or 4,300 W, 120/208V or 120/240V
Two ceramic heating elements side by side in one 66" housing keep a deep pass-through or holding area hot from higher above the food.
The Hatco UGAL-66D is an Ultra-Glo ceramic dual infrared strip heater with lights. Two ceramic elements sit side by side in an extruded aluminum housing, with a 3" spacer between them, so one 66" unit covers a deeper holding area. The ceramic heat source lets you mount it higher, which gives cooks and servers more working room. 5 shatter-resistant incandescent lights show off the food. Voltage is set when you order: 120/208V (4,220 W) or 120/240V (4,300 W), single phase. The lights run on 120V and the heat runs on 208V or 240V.
Each of the two circuits may need its own circuit breaker; have your electrician check the wiring diagram supplied with the unit.
The ceramic element lets the unit hang higher than a standard strip heater, so there is more working clearance under it.
Two elements side by side with a 3" spacer make the unit 15" deep. Hatco recommends a dual unit for a 20" to 24" deep pass-through.
The heat pattern concentrates heat at the edges, where heat loss is greatest, so food at the sides stays as hot as food in the middle.
The 66" continuous extruded aluminum housing does not sag. Clear anodized aluminum is standard.
5 coated, shatter-resistant incandescent bulbs light the food and guard against bulb breakage.
It comes with toggle switches and indicator lights, either in an attached control box or in a remote control enclosure.
UGAL-66D is built for 120/208V or 120/240V, single phase. Pick the one that matches your building when you order. It uses two circuits; at 120/208V they draw 9.4 A and 11.9 A, at 120/240V 8.3 A and 10.8 A.
Hatco recommends 18" to 22" above the food for standard watt dual units. With the 3" spacer the target holding width is about 21".
The standard 3" spacer makes the unit 15" deep; the optional 6" spacer adds 3" for an 18" deep unit and a wider holding area. This listing is the 3" spacer version.
Adjustable angle brackets, leads in a 3 ft. conduit whip, and toggle switches with indicator lights in an attached control box or remote control enclosure. Tubular stands and longer leads are factory options.
Yes, at the time of purchase: Designer colors (Warm Red, Black, Gray Granite, White Granite, Navy Blue, Hunter Green, Antique Copper) and Gloss finishes (Glossy Gray, Bold Black, Gleaming Gold, Brilliant Blue, Radiant Red). Clear anodized aluminum is standard. Non-standard colors are non-returnable.
Hatco's limited warranty runs 18 months from shipment or product registration, whichever is later. The spec sheet says the ceramic heating elements are warranted against burnout for one year. Light bulbs are not covered.
The spec sheet shows UL and NSF marks for all dual units (cULus applies only up to 36" widths) and a Made in USA mark.
Specs
| Manufacturer | Hatco |
|---|---|
| Model Number | UGAL-66D |
| Series | Ultra-Glo Ceramic Dual Infrared Strip Heater with Lights |
| Spacer | 3 Inch, Standard |
| Shipping Weight | 40 lb. |
| Shipping Weight Note | Add 2 to 8 lb. for a remote control enclosure |
| Width | 66 Inches |
| Depth | 15 Inches |
| Height | 2.5 Inches |
| Depth with Attached Control Box | 18-7/8 Inches |
| Voltage | 120/208 or 120/240 Volts |
| Phase | Single Phase |
| Wattage | 120/208V: 4,220 Watts120/240V: 4,300 Watts |
| Amps | 120/208V: 9.4 A + 11.9 A120/240V: 8.3 A + 10.8 A |
| Circuits | 2 Circuits; each may need its own breakerCircuit 1 Heat: 1,960 W at 208V, 2,000 W at 240VCircuit 2 Heat and Lights: 2,260 W at 120/208V, 2,300 W at 120/240V |
| Connection | Hardwired, Leads in 3 ft. Flexible Conduit Whip |
| Element | 2 Ceramic Infrared Elements, Standard Watt |
| Heat Pattern | Pre-Focused |
| Lights | 5 Shatter-Resistant Coated Incandescent Bulbs |
| Controls | Toggle Switches and Indicator Lights in Attached Control Box or Remote Control Enclosure |
| Housing | Continuous Extruded Aluminum, Clear Anodized |
| Mounting Height | 18 to 22 Inches, Target Width About 21 Inches |
| Clearances | Non-Combustible Surroundings Only1 Inch Below Shelf3 Inches from Back Wall |
| Factory Options | Designer Color or Gloss HousingExtra LampsNon-Adjustable Tubular Stands 18 to 26 InchesExtended Leads to 20 ft.Remote Control Enclosure with Toggle or Electronic Infinite Control |
| Accessories | Chef LED Bulbs 3000K or 4000K |
| Certifications | UL, NSF |
| Country of Origin | Made in USA |
| Warranty | 18 Months Limited |
| Warranty Notes | From shipment or registration, whichever is laterCeramic elements warranted against burnout 1 yearBulbs not covered |
Certifications
Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.
