Duke FCP1-SB 1-Well Flush Mount Drop-In Cold Pan, Standard Body, Touch Screen Control, 120V
Description
A 1-well refrigerated drop-in that holds pre-chilled food in pans set flush with your counter top.
The Duke FCP1-SB is a 1-well flush mount cold pan with a heavy gauge 300 Series stainless top and stamped wells that hold 12" x 20" pans up to 6" deep flush with the top. Each well has its own coil, a drain manifolded to one location, and R448A refrigeration with a TXV control. It plugs into 120V at 3.7 A on a 6 foot cord, and wells reach set point in about 30 minutes per the Duke manual.
Will it fit · Will it hook up
- Outside size
- 18-13/16" long x 26" front to back x 24" high, including the compressor below
- Counter cutout
- 17.5" x 24.625" (length x width)
- Power
- 120V 60 Hz, 432 W, 3.7 A; 6 ft. cord, NEMA 5-15 plug; one 15 A dedicated circuit
- Drain
- Drain in each well, manifolded to one location; hose for a drain pan or floor/sink drain
- Air flow
- Open body: no shroud or exhaust needed. Closed body: bottom exhaust min. 400 sq. in. or rear exhaust min. 200 sq. in.
Duke warns that poor ventilation around a drop-in refrigerated unit will burn out the compressor and void the warranty.
Pans flush with the top
Stamped top wells hold 12" x 20" pans up to 6" deep flush with the counter, not recessed, on 14" centers.
Coil on every well
Each well has its own refrigeration coil, with a TXV control for steady performance.
One drain line
Every well has a drain, manifolded to one location; the drain hose can run to a drain pan, floor drain or sink drain.
Fits Thurmaduke bodies
Uses the same counter cutout as standard Duke N7 cold pans, so it fits Thurmaduke bodies; the compressor slides out for service.
Touch screen control
An intuitive touch screen, on/off switch and Wi-Fi and Bluetooth connectivity.
Delivery and setup
- Inspect the crate for damage before you sign, and note any damage on the delivery receipt.
- Duke lists 150 lb. and 10.2 cu. ft. crated, freight class 100, shipped F.O.B. Sedalia, Missouri.
- Set the unit in the cutout on a bead of food grade silicone and support it from below, as the Duke manual describes.
- Plug it into its own 15 A, 120V circuit. Do not use an extension cord.
- It holds pre-chilled food; it is not designed to chill product. Shut it down daily for defrosting and cleaning.
Questions buyers ask
What pans does it hold?
1 standard 12" x 20" pan up to 6" deep, flush with the top. It also takes 1/2 and 1/3 size pans.
What power does it need?
120V, 60 Hz, 432 W and 3.7 A on a 6 ft. cord with a NEMA 5-15 plug. Duke calls for one 15 A dedicated circuit. A condensate evaporator, where offered, adds 300 W and 2.6 A.
How fast does it cool down?
The Duke manual says wells reach set point in about 30 minutes. Load only pre-chilled food.
Does it need a drain?
Each well has a drain, manifolded to one point, with a hose for a drain pan or a floor or sink drain. A no-drain version is offered, required for California.
What certifications does it have?
The Duke spec sheet shows UL and cUL listing marks and the UL EPH Classified mark to NSF/ANSI 7.
Specs
| Manufacturer | Duke |
|---|---|
| Model Number | FCP1-SB |
| Series | Drop In Flush Mount Cold Pan |
| Type | Flush Mount Drop-In Cold Pan, 1 Well |
| Shipping Weight | 150 lb. |
| Crated Cube | 10.2 cu. ft. |
| Freight Class | 100 |
| Width | 18-13/16 Inches |
| Depth | 26 Inches |
| Height | 24 Inches |
| Counter Cutout | 17.5" L x 24.625" W |
| Control Cutout | 3.75" x 3.44" |
| Capacity | 1 Full-Size 12" x 20" Pans |
| Pan Depth | Up to 6" Deep, Flush with TopAlso Accepts 1/2 and 1/3 Size Pans |
| Well Spacing | 14" Horizontal |
| Voltage | 120 Volts |
| Hertz | 60 |
| Wattage | 432 Watts |
| Amps | 3.7 Amps |
| Plug Type | NEMA 5-15P |
| Cord | 6 Foot Power Cord |
| Circuit | One 15 Amp Dedicated Circuit |
| Refrigerant | R448A |
| System | Individual Coil for Each WellTXV ControlOpen Suspended Compressor CompartmentCompressor Slides Out for Service |
| Top | Heavy Gauge 300 Series Stainless SteelStamped Top Wells |
| Exterior | Paint Grip Steel, One Body Housing All Wells |
| Insulation | High Density CFC-Free Polyurethane Foam, Zero GWP and Zero ODP |
| Drain | Drain for Each Well, Manifolded to One Location |
| Control Type | Touch ScreenOn/Off SwitchWi-Fi and Bluetooth Connectivity |
| Factory Options | No-Drain, Required for CaliforniaSlanted KitDigital Control Mounted to Side of Compressor CageCondensate EvaporatorStainless Louver Panel for Compressor Cage |
| Certifications | UL, cUL, UL EPH Classified NSF/ANSI 7 |
Certifications
Payment & Security
Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.
What Our Customers Say

