Hatco 3CS-4 Sanitizing Sink Heater for 3-Compartment Sinks, 4.5 kW, 208/240V 1-Phase or 480V 3-Phase
Description
Keeps the rinse water in your third sink compartment at the 180°F the NSF standard calls for, from a 4.5 kW heater that hangs under the sink.
The Hatco 3CS-4 mounts under the center of a 3- or 4-compartment, pot and pan or bar sink and keeps a continuous supply of 180°F sanitizing rinse water without taking up sink space. At 4.5 kW it is sized for a compartment of 16"-18" square, based on 140°F supply water and a 30-minute preheat. It runs on 208V or 240V single phase, or 480V 3-phase open delta; tell us the voltage of your service when you order, because Hatco builds the heater for one.
Will it fit · Will it hook up
- Outside size
- 6-3/4" W x 16-7/8" D x 12-5/8" H, under the sink
- Sink compartment
- 16"-18" square; two 2" holes in the sink bottom, template included
- Power
- Hardwired: 208V Single Phase: 22 A, 10 AWG wire, 30 A breaker; 240V Single Phase: 18.8 A, 10 AWG wire, 30 A breaker; 480V 3-Phase Open Delta: 9.4 A, 14 AWG wire, 15 A breaker
- Drain
- 3/4" hose connection; may be plumbed to an open-sight waste drain
- Water
- Treat water harder than 3.0 grains per gallon
Breakers and fused disconnects are mounted remote and wired by your electrical contractor.
Under-sink design
The heater hangs below the third compartment, so the full sink stays free for racks and ware.
Dual reservoir tank
A stainless steel tank has one reservoir for the submerged element and one that traps soil and empties through a side drain.
Overtemp protection
An Energy Cut-Off (ECO) shuts the heater down if water runs hotter than normal; a red light tells staff to refill and reset.
Simple controls
An On/Off toggle switch starts the heater and a yellow light shows when power is on.
Ready to install
It ships with all gaskets and fittings, and self-contained unions connect it to the sink fittings.
Open delta 3-phase
The 3-phase version uses open delta wiring, which draws more amps than a balanced 3-phase B model of the same kW.
Delivery and setup
- Inspect the carton for damage before you sign, and note any damage on the delivery receipt. Approximate shipping weight is 24 lb.
- A licensed electrician must hardwire the heater to a properly sized fused disconnect or circuit breaker; no cord is supplied.
- Cut two 2" holes in the bottom of the third compartment with the full-size template provided, then connect the heater with the supplied fittings and unions.
- Fill the sink with water before you turn the power on. Treat incoming water harder than 3.0 grains per gallon; Hatco does not cover failures from lime or sediment buildup.
Questions buyers ask
What size sink does it fit?
The 3CS-4 is sized for a sink compartment of 16"-18" square. Hatco sizes sink heaters at 2,000 watts per square foot of vessel top, with 140°F supply water and a 30-minute preheat.
What electrical service does it need?
It is hardwired, with no cord. 208V Single Phase: 22 A, 10 AWG wire, 30 A breaker; 240V Single Phase: 18.8 A, 10 AWG wire, 30 A breaker; 480V 3-Phase Open Delta: 9.4 A, 14 AWG wire, 15 A breaker.
How is it installed?
It mounts under the center of the third compartment. You cut two 2" holes in the sink bottom using the full-size template, and the heater attaches to the supplied plumbing fittings with self-contained unions. The drain has a 3/4" hose connection.
Does it meet the 180°F sanitizing rule?
Yes. Hatco states the 3CS meets the NSF standard of 180°F for dish sanitizing. The series carries UL, cUL and NSF certification.
What options are there?
Options must be ordered with the heater: an all stainless steel body and base, a built-in temperature monitor or a temperature light (not both), and a security package with Torx screws and a control cover. A flush kit with hose, stopper and adapter is sold as an accessory.
What is the warranty?
Hatco gives 1 year parts and labor, and the 3CS tank has 1 year parts and labor plus 4 more years parts only. Failures caused by lime or sediment buildup are not covered.
Specs
| Manufacturer | Hatco |
|---|---|
| Model Number | 3CS-4 |
| Series | 3CS Sanitizing Sink Heater |
| Shipping Weight | 24 lb. |
| Width | 6.75 Inches |
| Depth | 16.88 Inches |
| Height | 12.63 Inches |
| Sink Area | 16"-18" Square |
| Sizing Basis | 2,000 W per sq. ft. of vessel top, 140°F supply water, 30-minute preheat |
| Rinse Water Temperature | 180°F |
| Power Rating | 4.5 kW |
| Voltage | 208, 240 or 480 Volts |
| Phase | Single Phase or 3-Phase Open Delta |
| Amps, Single Phase | 208V: 22 A, 10 AWG, 30 A breaker240V: 18.8 A, 10 AWG, 30 A breaker |
| Amps, 3-Phase Open Delta | 480V: 9.4 A, 14 AWG, 15 A breaker |
| Connection | Hardwired, 0.75" conduit knockout; no cord |
| Sink Connection | Two 2" holes in sink bottom, fittings and unions supplied |
| Drain | 0.75" hose connection |
| Water Quality | Treat water over 3.0 grains per gallon hardness |
| Controls | On/Off Toggle SwitchYellow Power LightRed Overtemp and Reset LightEnergy Cut-Off |
| Exterior | Stainless Steel Front, Silver-Gray Hammertone Powder-Coated Body, Black Base |
| Tank | Stainless Steel, Dual Reservoir with Soil Trap and Side Drain |
| Options | All Stainless Steel Body and BaseBuilt-In Temperature Monitor or Temperature Light, Not BothSecurity Package, Torx Screws and Control Cover |
| Accessories | FR-FLUSH Flush Kit: Hose, Stopper and Adapter |
| Certifications | cULus, NSF |
| Made In | USA |
| Warranty | 1 Year Parts and LaborTank 1 Year Parts and Labor Plus 4 Years Parts Only |
| Warranty Notes | Lime or sediment failures not covered24/7 parts and service assistance in US and Canada |
Certifications
Payment & Security
Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.
What Our Customers Say

