Hatco HCSSBR-4818 Remote Hot/Cold Built-In Simulated Stone Shelf, 48" x 18", R-513A Condenser, 120V
A flush simulated stone shelf that switches between hot and cold display, with a remote condensing unit you place where it fits.
The Hatco HCSSBR-4818 is a remote hot/cold built-in simulated stone shelf with a 48" x 18" Swanstone surface, bottom mounted, flush with the countertop. It heats or chills from one footprint and changes modes in as little as 30 minutes. This R version ships with a remote 1/3 HP condensing unit that uses R-513A refrigerant, plus an unattached control box and TXV, so the fabricator can place the condenser where it fits best in the cabinet.
Plan the condensing unit location and ventilation before the shelf arrives; refrigerant lines are brazed in the field.
The same shelf switches between heated and chilled display. Hatco rates the change at as little as 30 minutes, so one footprint covers breakfast, lunch and dinner menus.
The control box has a power switch and separate HOT and COLD digital controllers. Cold setpoints run 10°F to 50°F and hot setpoints 65°F to 192°F; factory presets are 25°F and 180°F.
A thermal break around the shelf reduces condensation and temperature transfer onto the countertop next to it.
The Swanstone simulated stone surface mounts from below, flush with the countertop. Ash Gray is standard; Hatco notes that stone patterns vary.
The 1/3 HP condensing unit ships loose with sight glass, service valves, dryer/filter and receiver for easier service. Lines can run up to 50 ft.
The electronic temperature control box ships loose with a 4 ft. lead wire for remote mounting on a vertical surface, outside the heat zone.
Yes. The HCSSBR-4818 includes a remote 1/3 HP condensing unit using R-513A, shipped loose with the control box and TXV. Hatco ships the condenser without a refrigerant charge, so the installer charges the system.
120V, 60 Hz, single phase. Hatco rates the HCSSBR-4818 at 6.8 amps, with 450 W cold side and 815 W hot side.
48.375" wide by 18.375" deep with 3/8" corner radii, plus a 13-1/8" x 5-5/8" opening for the control box.
In about 30 minutes. When you switch to cold, a five-minute delay runs before the condensing unit starts as a safeguard.
Ash Gray Swanstone simulated stone is standard. Birch or Ice Swanstone, Rem, Domoos or Soke Dekton surfaces, and black or white glass-ceramic tops are order options; non-standard finishes are non-returnable.
Hatco lists a one year parts and on-site labor warranty as standard, with 24/7 parts and service assistance in the U.S. and Canada. A four year parts-only compressor extension can be added at time of purchase.
Specs
| Manufacturer | Hatco |
|---|---|
| Model Number | HCSSBR-4818 |
| Series | HCSSBR Remote Hot/Cold Built-In Simulated Stone Shelf |
| Type | Hot/Cold Shelf, Remote Condenser and Control Box |
| Shipping Weight | 187 lb. |
| Width | 51 Inches |
| Depth | 21 Inches |
| Height | 7.537 Inches |
| Capacity | 48" x 18" Heated/Cooled Surface |
| Counter Cutout | 48.375" W x 18.375" D with 0.375" Radii |
| Control Box Cutout | 13.125" W x 5.625" H10" Installation Depth |
| Voltage | 120 Volts |
| Hertz | 60 Hz |
| Phase | 1 |
| Amps | 6.8 Amps |
| Cold Side Watts | 450 Watts |
| Hot Side Watts | 815 Watts |
| Other Voltages | 220, 230 and 240V Versions for International Markets, Set at Order |
| Compressor | 1/3 HP |
| Refrigerant | R-513A |
| Condensing Unit | Remote, Shipped LooseSight Glass, Service Valves, Dryer/Filter, Receiver |
| Max Line Length | 50 ft. |
| Total Heat of Rejection | 2,855 BTU/hr |
| Temperature Range | 10°F to 192°F |
| Cold Setpoint Range | 10°F to 50°F, Factory Set 25°F |
| Hot Setpoint Range | 65°F to 192°F, Factory Set 180°F |
| Mode Change Time | As Little as 30 Minutes |
| Room Ambient | 65°F to 86°F |
| Surface | Swanstone Simulated Stone, Ash Gray StandardBottom Mount, Flush with Countertop |
| Finish Options | Birch, IceDekton Rem, Domoos, SokeBlack or White Glass-Ceramic TopNon-Standard Finishes Non-Returnable |
| Control Type | Remote Electronic Control BoxPower SwitchHOT and COLD Digital Controllers4 ft. Lead Wire |
| Certifications | cULus, NSF Component |
| Country of Origin | Made in the USA |
| Warranty | 1 Year Parts and On-Site Labor |
| Warranty Details | Optional 4-Year Parts-Only Compressor Extension at Time of Purchase, U.S. and Canada24/7 Parts and Service Assistance, U.S. and Canada |
Certifications
Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.
