Equipex DRIC 3000 Leopard Drop-In Induction Cooker, 11" Coil, 3.0 kW, 208/240V 1-Phase
Description
A 3.0 kW single-zone drop-in induction cooker with a large 11-inch coil that sits flush in the counter of a cooking line or display station.
The Equipex DRIC 3000 is an Exclusive Leopard drop-in induction cooker with a stainless steel case, a 4 mm vitroceramic glass top and an 11" coil for stockpots and large pans. The integral touch panel sets 25 power levels or 110 temperature levels from as low as 86°F, with two presets and a 99-minute timer. Two cooling fans allow all-day use. It runs on 208/240V single phase, 13/15 A, with a NEMA 6-20P plug.
Will it fit · Will it hook up
- Outside size
- 17-1/2" W x 23" D x 6-3/4" H
- Counter cutout
- 16-1/4" W x 21-3/4" D
- Below the counter
- 6" clearance under the unit with adequate ventilation; not above an oven or other heat source
- Power
- 208/240V, 50/60 Hz, 1-phase, 3.0 kW, 13/15 A; NEMA 6-20P plug
- Circuit
- Dedicated circuit rated at least 25% over the maximum current, per NEC
Do not install it in a fully enclosed cabinet; the cooling fans need fresh air below the counter.
11-inch coil
The large 11" coil heats stockpots and wide pans evenly, for prep work and a la carte cooking.
Power or temperature
25 power levels plus 110 temperature levels from as low as 86°F, shown in °F or as a 4-digit power level.
Integral controls
On/off, +/-, two presets and a 99-minute timer are built into the glass top.
Two cooling fans
Fans and a removable grease filter keep the electronics cool for all-day service.
Built-in protection
Pan detection, power supply monitor, empty pan and overheating protection, small article protection and oil auto-ignition shutoff.
Delivery and setup
- Inspect the carton for damage before you sign, and note any damage on the delivery receipt. Equipex says shipping damage claims are filed with the carrier, so keep the packaging.
- Have the counter cut to 16-1/4" x 21-3/4" before it arrives, with 6" of ventilated space below.
- The installer seals the unit into the cutout following the Equipex manual; leave 2" clearance at the sides.
- Plug it into a grounded 208/240V single-phase outlet on a dedicated circuit; the NEMA 6-20P plug is fitted.
Questions buyers ask
What cutout does it need?
16-1/4" W x 21-3/4" D. The unit is 17-1/2" W x 23" D x 6-3/4" H, so plan at least 6" of open, ventilated space under the counter.
What outlet does it need?
A grounded 208/240V single-phase receptacle for the NEMA 6-20P plug on a dedicated circuit rated at least 25% above the 15 A maximum draw.
Can it go above an oven?
No. Equipex says not to install it above any heat source such as an oven, and not in a completely enclosed space.
What pans work on it?
Induction-ready, ferromagnetic pans. If a magnet sticks to the bottom, it works. Equipex recommends 3, 5 or 7 ply pans.
What is the warranty?
Equipex's induction warranty statement gives a limited two-year parts and labor warranty from shipment. The DRIC spec sheet prints three years; confirm with Equipex if it matters for your purchase.
Specs
| Manufacturer | Equipex |
|---|---|
| Model Number | DRIC 3000 |
| Series | Exclusive Leopard |
| Type | Drop-In Induction Cooker, Single Zone |
| Shipping Weight | 27 lb. |
| Width | 17-1/2 Inches |
| Depth | 23 Inches |
| Height | 6-3/4 Inches |
| Counter Cutout | 16-1/4" W x 21-3/4" D |
| Clearance Below | 6" with Adequate Ventilation |
| Voltage | 208/240 Volts |
| Hertz | 50/60 Hz |
| Phase | 1 |
| Amps | 13/15 Amps |
| Power | 3.0 kW |
| Plug Type | NEMA 6-20P |
| Cooking Zones | 1 |
| Coil Size | 11 Inches |
| Power Levels | 25 |
| Temperature Levels | 110, as Low as 86°F |
| Control Type | Integral Capacitive TouchOn/Off, +/-, 2 Presets, 99 Minute Timer°F or 4-Digit Power Display |
| Safety Features | Pan DetectionPower Supply MonitorEmpty Pan and Overheating ProtectionSmall Article ProtectionOil Auto-Ignition Shutoff |
| Exterior | Stainless Steel |
| Cooking Surface | 4 mm Vitroceramic Glass |
| Cooling | Two Cooling FansRemovable Grease Filter |
| Certifications | cETLus Listed to UL 197 and CSA C22.2, ETL Sanitation to NSF 4 |
| Warranty | Limited 2 Year Parts and Labor |
| Warranty Note | DRIC spec sheet 10/22 prints Limited Three-Year Parts and Labor |
Certifications
Payment & Security
Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.
What Our Customers Say

